Description
Adapter for lathe chucks, М33 * 3.5mm / holder D10mm. It is used for mounting a chuck with M33x3.5 connecting thread in the tailstock quill. The shank with a diameter of 10mm can be clamped into both a drill chuck and a collet. Material - steel 20.
Convenient for gluing segment rings, and coaxial gluing of halves of projects.
Production of the PETROGRAD factory.
Made in Russia.
Share / Save Link:
Specs
Reviews
Instructions ()
Publications
Recommended products
The book `Practical course of woodturning art` + Atlas of drawings, M. Netyksa
The book is about woodturning art as a separate craft that includes not only the work on the lathe. This book was a basic textbook on turning wood and bone throughout the first half of the twentieth century. Moscow 1910 / Reprint edition of St. Petersburg 2017. Format 145x215 mm, hard tissue binding, 440 pages. Also included is an album of drawings attached to the 1910 edition. The author is M. A. Netyksa, a member of the Scientific Department of the Society for the Distribution of Technical Knowledge.
Table of contents.
Division I. Machines, equipment and tools
Division II. Work techniques and special devices
Division III. Various materials in turning
Division IV. Adhesives, putties and surface grinding
Division V. Decoration and Surface Finishing Turning Works